How to pose a sticker déco?

Here some decorative easy ways to help you to pose these stickers very tendency, without making folds nor of bubbles.
How to pose a sticker on an object?
For the objects of small size, any particular difficulty: one takes off the adhesive of the paper board on which it is sold, and one applies it such as it is, with a little delicacy and attention all the same, directly to the object which one wishes to decorate.
How to pose a sticker on a wall or a piece of furniture?
The mural stickers comprise three elements: sticker itself, which is the only element which will remain on the wall once the installation carried out, the liner or white self-adhesive paper which is under the decoration when you receive it, and finally the transparent film which is stuck on the sticker, and whom one calls types it. For posing large a sticker well mural, without bubbles nor folds, it is enough to follow some rules simple, and always to progress carefully, without wanting to make too quickly. The stickers of good quality are generally delivered with a scraper, which must initially be used to smooth transparent film (slap) on the sticker, in order to make sure that these two elements adhere perfectly one to the other. Then, on the level of the edge which will form the top of the decoration, take off the liner on approximately 1cm of width, and cut this one in order to have a band sticking which will be used to position the sticker at the wanted place, before beginning the installation itself.
Thus place the sticker at the wanted place, it will hold all alone thanks to the band of slap of 1 cm broad, on which you will strongly support to ensure you of his good adherence against the wall. Place then a hand under the decoration, that you can upwards fold up for you to help there, and start to take off the liner by below, gradually. By doing this, use the other hand to smooth always types it on the wall as you take off the liner, on the basis of the center towards one of the edges, then center towards the other edge. Continue thus until in bottom of the decoration. And here! It is enough for you now to take off very delicately the transparent film, or types, which recovers the sticker, and to contemplate the result.
How to pose a sticker on a car?
The surface of a car is seldom plane, and it would be thus difficult to use the same method for a vehicle as for a wall, but fortunately, it exists an excellent solution, possible because one can without any problem wet a car, which is not the case for a wall in the house. It is thus enough initially to separate the sticker from the liner, then to vaporize soapy water on the side sticking of the sticker before applying it to the vehicle. One smoothes of sound better to the hand to start, then one passes a scraper to drive out the most possible water and to make well adhere the sticker. One can even finish using a rag for withdraws the most possible water and ensure a better smoothing. One then lets dry at least an hour before withdrawing types it.